STAY WILD CARD TUTORIAL - SHANNAH BARTLE

Shop the products

Uniquely Creative Products Used:

• UCP2767 Tinker paper 
• UCP2770 Underground paper
• UCP2771 Urban paper
• UCP2773 Steampunk Graffiti Creative Cuts
• UCE1862 Black twine
• UCCS139 Butterflies Cut-a-part (Add-on)
• UCCA1761 Shadow cardstock (Add-on)

Other Products Used:

• UCE1872 Fussy cutting scissors
• UCE1916 Fine glue pen
• UCE1945 Fineliner pens
• UCE1961 Foam mounts – strips
• Double-sided tape
• Trimmer, scoreboard, bone folder
• Black Soot Distress Oxide ink
• Die cutting machine

Instructions:

1. Cut a 30cm x 15cm piece of Shadow cardstock. Score and fold in half to make a 15cm square card. Then score the front of the card in half (at 7.5cm), and fold back on itself – See image 1.
   
   
   
2. Cut a 28.5cm x 14.5cm panel which includes the machine images from Tinker paper. Cut two 7cm wide sections from the left side of the panel, and ink all the edges – See image 2.
   
   
   
3. Adhere the two smaller panels inside the left of the card, and the remaining square to the inside right of the card, leaving thin borders of black all around.
   
   
4. Cut a 10cm square of Underground paper, ink the edges with black ink, then matt with a 10.5cm square of black cardstock – See image 3.
   
   
   
5. Select the two pipe frames, panda image and ‘stay wild’ sentiment from the Creative Cuts. Trim a scrap from the reverse of Underground paper to 7.3cm x 8cm and adhere to the back of one pipe frame using a fine glue pen. Adhere the panda and sentiment on top then use foam strips to attach the second pipe frame on top
   – See image 4.
   
   
   
6. Wrap black twine around the Underground square, attaching the ends at the back, then attach the finished panda frame onto the front using foam tape – See image 5.
   
   
   
7. Apply glue to ONLY the left side of the square panel, then attach to the left panel of the card, making sure it looks centred when the card is folded closed – See image 6.
   
   
   
8. Adhere a cog from the Creative Cuts to the top left and bottom right corner of the square, then layer two more inside the card, so that they lay nicely when the card is open. Use a black fineliner pen to add lines for a message in the centre panel – See image 7.
   
   
   
9. Select the ‘Break the Mold’ sentiment, and a cog, bee and butterfly from the Creative Cuts. Also fussy cut a light globe from Urban paper and another butterfly from the cut-a-part sheet.
   
   
10. Decorate the right inside of the card with these elements, making sure to check that they are placed underneath where front square panel covers them when closed. Attach the double layered butterfly to the clock at the bottom right image to finish – See image 8.